Raft Separation Distance : Allow Negative numbers
Posted: Wed May 11, 2016 11:40 am
While printing with multiple materials, there are times when i need to use Material A for the raft and Material B for the support.
In that case i need to really have my support bite into the raft. I DON'T want them to separate.
Even when the Separation Distance is set to ZERO it still adds an offset in the gcode. It can be seen in the preview as well.
This makes HIPS curl off of the raft and ruins prints.
If i can tune this to a negative number it will prevent a lot of hand hacking of the gcode.
In that case i need to really have my support bite into the raft. I DON'T want them to separate.
Even when the Separation Distance is set to ZERO it still adds an offset in the gcode. It can be seen in the preview as well.
This makes HIPS curl off of the raft and ruins prints.
If i can tune this to a negative number it will prevent a lot of hand hacking of the gcode.