Hello esteemed makers
so far buying s3D has been the best decision ever.. I havnt had to mess with much and get great looking prints using default settings.
There is 1 issue im seeing however that i cant figure out.
during printing, my machine changes temperature settings slightly from my chosen settings.
for pla i want
70 - bed
210 - extruder
In S3D ive set
extruder - Layer 1 temp - 210
heated bed - layer 1 temp - 70
i slice and save toolpath to disk..then upload to octoprint for printing.
when i start the job, The settings in octoprint show target as 70 bed / 210 extruder.
However once the print begins, it increase the target extruder to 215 C and lowers the Bed Temp to 60 C
Im not so concerned about extruder temp but at 60C my prints slightly curl off bed ( on kapton tape )
why are my bed temps lowering 10 degrees?
Can anyone point me in the right direction?
Thanks