Simplify3D User Forum

Anyone know why the first layer on top of support becomes a bridge layer?

It's suppose to be 3 solid layer, but it starts with one bridge layer an then two solid layers.

It happens on all models I try that I use support on.

A bridging layer is a solid layer.....but laid down in a way that reduces or eliminates any sagging because its laid down mainly over fresh air.

So you ARE getting three top solid layers.

If the first layer was not put down as a bridging layer, you'd probably have to specify 4 or 5 top layers to guarantee a good top surface.

OK

it dosn't come apart on this small part, but on bigger parts, it dosn't get in contact with the perimeter shells and comes loos and thready. looks like shit.