Simplify3D User Forum

Posted: **Mon Jun 20, 2016 9:03 pm**

After the first layer or so, the print will "pause". If I'm running in USB control mode, I can press pause and the resume and it will keep going for a layer or so. On SD, The printer pause and resume commands do not work. This problem just started after a brief hiatus of just a couple weeks. I don't think anything changed. Any thoughts?

Posted: **Wed Jun 22, 2016 7:03 am**

If it's pausing from the SD card, then it sounds like you either have a bad command in your gcode or something is wrong with your firmware

Posted: **Thu Jun 23, 2016 4:43 pm**

It's pausing regardless. But I will try updating the firmware on the printer. Thanks

Simplify3D User Forum

Print "pauses" on SD or USB

Print "pauses" on SD or USB

Re: Print "pauses" on SD or USB

Re: Print "pauses" on SD or USB