Page 1 of 1
PETG profile
Posted: Sun Jun 26, 2016 3:23 pm
by port513
Not a show stopper but it would be nice if a PETG profile would be installed as default.
Is there a good PETG profile for my FlashForge Finder to use?
/Henke
Re: PETG profile
Posted: Wed Jul 06, 2016 1:41 am
by port513
No PETG profile?
Does anyone print using PETG?
If yes, how do I get the best print from my FF Finder?
/Henke
Re: PETG profile
Posted: Wed Jul 06, 2016 5:43 am
by CompoundCarl
It's very easy to add a new filament profile. This video explains it in great detail:
https://www.youtube.com/watch?v=JFynhtvPBPQ
So just follow those instructions and then you can experiment with what temperatures work best. I frequently run several small prints at 10 degree increments to find what works best.
Re: PETG profile
Posted: Sun Jul 10, 2016 4:24 am
by BramV
While it is easy to add a new profile, I think PETG is becoming a popular material, so I would agree that it could be added by default.