Rough Surface from supports
Posted: Tue Jul 12, 2016 11:34 pm
by mash3d
Hi, I've been getting a rough surface where the support structures are. They come off ok but still leave a bit of a mess. The upper surface is fine. What settings do I need to adjust to clean this up.
By the way this is PLA. I can post the settings if needed.
Thanks
20160712_194044 by
michael32766, on Flickr
Re: Rough Surface from supports
Posted: Wed Jul 13, 2016 6:38 am
by CompoundCarl
There has to be 10 other threads about this exact topic from the last month. See if you can search and find some similar topics.
Re: Rough Surface from supports
Posted: Wed Jul 13, 2016 9:36 pm
by mash3d
Thank you I appreciate your taking time to answer. I looked at the printing trouble shooting guide and did a search for "Supports". That search unfortunately came back with 98 pages and 972 posts.
I'm trying to narrow it down a bit.
Does the issue come from the Horizontal offset from part or the support pillar resolution?
Thanks,
Re: Rough Surface from supports
Posted: Thu Jul 14, 2016 5:57 am
by CompoundCarl