Simplify3D User Forum

Posted: **Wed Jul 13, 2016 6:28 am**

Hello guys!

I'm experiencing some troubles in printing over USB.

When i click on "Begin Printing over USB" after the slicing process nothing happens.. Simplify doesn't even start heating the Tools...
In the "Communication" tab inside the "Machine Control Panel" an error message is showing:
READ: rs N0

Any tips?

Posted: **Wed Jul 13, 2016 6:50 am**

Sounds like the firmware isn't accepting any commands. Have you tried sending it other manual commands using the terminal?

Posted: **Wed Jul 13, 2016 6:54 am**

CompoundCarl wrote:[...] Have you tried sending it other manual commands using the terminal?

Absolutely! Everything work except for the printing process

Simplify3D User Forum

Print over USB doesn't start!

Print over USB doesn't start!

Re: Print over USB doesn't start!

Re: Print over USB doesn't start!