How to configure bed level?

[castmemberzack]

In Mattercontrol you can adjust your Z-axis for each leveling point and it will remember that point. When I manually do it in Simplify, it doesn't hold it. Can I import my Z settings from Mattercontrol into Simplify for bed leveling?

Thanks,

Zack


Oh, I'm using an R1+.

[CompoundCarl]

You mean just a Z-axis offset? The auto-leveling on the R1+ takes care of adjusting for a tilted or unleveled bed. So the only thing you need to worry about is an extra Z-axis offset if the nozzle is too far from the bed.