Page 1 of 1
Is there a setting that disregards smaller features
Posted: Tue Jul 19, 2016 6:17 pm
by sealfab
The small strip is missing is its .5x1mm is there a setting that caused that to not get sliced?
Re: Is there a setting that disregards smaller features
Posted: Tue Jul 19, 2016 6:59 pm
by sealfab
I have a .5 nozzle and extrusion is set to .5 but if I change them both to .25 it will add it in. Why is that?
Re: Is there a setting that disregards smaller features
Posted: Tue Jul 19, 2016 7:58 pm
by dkightley
Try looking round the threads on the forum.....particularly this thread:
viewtopic.php?f=23&t=3471
Re: Is there a setting that disregards smaller features
Posted: Tue Jul 19, 2016 10:19 pm
by jimc
yes it take 2 perimeters to make that feature so if your ext width is set ot .5mm then that needs to be 1mm in width.