Simplify3D User Forum

Hi,

I have the issue that everything sliced with simplify3d won't be finished when printing.
It's only the last 6 to 10 lines.
Here is a picture where the left bottom corner of the top layer is missing.

Furthermore although I included the X axis will not home.

Any suggestions, especialy about the unfinished prints?

Thanks in advance.
Chris

Your picture isn't showing up for me..

Sorry, wrong URL.
Here it is:

Try putting an M400 at the beginning of your ending script
http://reprap.org/wiki/G-code#M400:_Wai ... _to_finish