Simplify3D User Forum

Hello,

I havent purhased this software yet, but I am thinking to buy it. Could anybody slice this Bulbosaur (model link) http://www.mediafire.com/download/2am2b ... xed_HI.stl and post a jpg screenshot (not a sliced gcode) of top view of single layers 168, 171,172?

Important gcode parameters for me are:
Top layers:2
Bottom layers:2
Outline parameters:3
infill:20%
infill type:rectlinear

Thanks in advance.

They already have a 2-week guarantee on the software, right? So if you want to try it out, just purchase it and give it a go. That's much easier than everyone trying to send you screenshots of every setting you need to check. Then if you don't like it, you can just ask for a refund.

Hope this helps!

Muggs wrote:Hope this helps!

Thank you very much!!!

CompoundCarl wrote:They already have a 2-week guarantee on the software, right? So if you want to try it out, just purchase it and give it a go. That's much easier than everyone trying to send you screenshots of every setting you need to check. Then if you don't like it, you can just ask for a refund.

I would love to do that, but the fact I live in Poland makes this operation complicated taxwise. Thanks for your help.