Simplify3D User Forum

Hi there,

I have a new CoreXY printer, direct E3D Titan Extruder and E3D V6 Hotend, my Filament i have tested is ABS.
The Firmware is Repetier dev Version with advance mode Disabled.

Now i have a lot of blobs and can't remove them. Days of prints but no solution to remove the blobs.

Maybe some one can help me to solve this issue.
Regards

Mac

I would suggest starting here: https://www.simplify3d.com/support/prin ... s-and-zits


It covers pretty much all of the suggestions I can think of

It's also possible that your ABS is wet and those blobs are defects from the water evaporating and pushing out filament or bubbling on extrusion.