printing multible parts sequentially with oozing shield...
Posted: Sat Sep 17, 2016 7:12 am
Hello Community, Hello Simplify3D,
why it's not possible to print the oozing shield, while printing multible parts sequentially?
i tried to use a full heigth brim, but the effekt on print quality is not the same.
But what's the differents between both (brim/oozing shield) in terms of able to print sequentially?
thank you very much in advance!
peter
why it's not possible to print the oozing shield, while printing multible parts sequentially?
i tried to use a full heigth brim, but the effekt on print quality is not the same.
But what's the differents between both (brim/oozing shield) in terms of able to print sequentially?
thank you very much in advance!
peter