Simplify3D User Forum

Tools Menu : Firmware Configuration : Macros Tab

Although the macro commands are saved, the Macro Name is not. They aren't saved, and on the machine control panel they are shown as Macro 1, Macro 2 and Macro 3.

This appears to be the case regardless of which machine type is selected.

Mine are saved just fine. Of course, you have to make sure you aren't overriding the firmware settings with your process (but I think you get a warning message if you are doing that, so you'd probably know if that was the case). But I just tried setting up a few different ones with different names and they saved as I would expect.

Mine save just fine also - and the news names show up on the buttons as soon as I disconnect and reconnect after selecting a new profile (with the new firmware settings).

My main issue is that I wish there more than just 3 of them. 3 macros isn't enough. It should be at least 6 - make another row of buttons available.