Simplify3D User Forum

Ever since I installed version 2.xx I noticed getting nozzle wipes on my prints every time the printer does quick moves among
different outlines or perimeters. How do I turn this action off?

In the "other" tab of your process panel there is an ooze control secton with this option there.

I've unchecked 1st option in ooze control which makes it wipe on every pass instead of just outside perimeters, what next?

hmmm, well i have that last box checked. tells it to wipe only for outer most perimeters. i havent really noticed any wiping action going on. that whole ooze control section is all new stuff with 2.0. i havent really messed with it much. you should send a email to support. i would assume right in the extruder tab of your process, under the coasting, you have the wipe nozzle box unchecked?

Yes I have that box under extruder wipe unchecked, it isn't much of an issue as far as quality goes just different behavior on my
M2 from previous S3D releases. Thanks for your advice.