Page 1 of 1
No print material choise
Posted: Sun Nov 06, 2016 10:51 am
by tux_on_tour
I have one printer on which I have no "Auto-configure for Material" tab anymore since the update.
Now all configs are gone for my Materials for this printer and that really (include swearing of your choice) !
Re: No print material choise
Posted: Mon Nov 07, 2016 4:50 am
by CompoundCarl
Well, it's pretty simple to check. Just go to File > Export FFF Profile to save your profile to your hard drive. Then open it in a text editor and look for the <autoConfigureMaterial> sections. If it doesn't have any, then you aren't going to see any in S3D. If there are a bunch of <autoConfigureMaterial> sections, but they aren't showing up in the software, then it would probably help if you posted the file here for others to test.
Re: No print material choise
Posted: Sat Nov 12, 2016 5:03 pm
by tux_on_tour
So there are none in the fff file. But before the update 3.1.1 there where a lot.
Now there are non and I cant even create one in this profile so now i have to start over.