Hi ,
After installing the new ver. of software the preview of the bed disappears right after it starts up. I can still load a model but I can not see it. If I go to prep for print the slice window opens and I can see the model them in it's sliced form.
Thanks for any help.
-
propologist
- Posts: 9
- Joined: Mon Dec 16, 2013 2:49 pm
-
CompoundCarl
- Posts: 2005
- Joined: Wed Aug 05, 2015 7:23 am
Re: Preview window disappears
Well did you enable the "build table" checkbox on the left side of the preview window?
-
propologist
- Posts: 9
- Joined: Mon Dec 16, 2013 2:49 pm
Re: Preview window disappears
Sorry, I am talking about the start up window not the slicer preview window. But yes that is checked in the slicer window. When I first installed it, it was all working fine. It is there when I am not connected to the printer. I am printing on a Leapfrog Creatr dual.
Thanks.
Thanks.
