S3D Support Wall Thickness Adjustment

[rogergh]

Hello guys!
I'm struggling on the support wall thickness generated by S3D.
The wall thickness is almost ranging from 0.6 - 0.8mm, removing it is a suicide. Got myself cut very badly from it.
Not even single one of them came out easily, both material use here is PLA (on printer: Felix Pro)

I tried tweak the support settings, it doesn't seems to help on the removal
Appreciate some help over on it, been trying for 2 days yet no good results

[CompoundCarl]

Your pictures aren't showing up for me, but there's lots of support separation settings that you can adjust if you need the support to break away easier. I would probably start with those.