Cannot get printer to extrude properly
Posted: Thu Nov 17, 2016 11:31 am
Just printing a super-basic spiral vase tube, to try and figure out what's going on with my perimeters.
When printed with Simplify, seems to under-extruding an incredibly large amount:
But with Cura, the layers are significantly better, but randomly won't finish the wall:
Pretty desperate to find a solution because neither repetier or simplify are able to get good quality prints done..
When printed with Simplify, seems to under-extruding an incredibly large amount:
But with Cura, the layers are significantly better, but randomly won't finish the wall:
Pretty desperate to find a solution because neither repetier or simplify are able to get good quality prints done..