Simplify3D User Forum

Hi all, how do I get s3d to retract when it finishes the Ooze shield ? I have retraction on, for both extruders and in the and in the advance tab I set checked and set the minimum travel to retract too 1mm with Ooze shield 3 mm offset yet it not retracting coming off the ooze shield and its depositing plastic on sides of my prints. Thanks

Uncheck the option "Only retract when crossing open spaces" and it will retract there. It will also retract every time the head makes a non-printing move, but that's the only way to make that work at the moment.

Add your voice here perhaps? viewtopic.php?f=9&t=5018