Simplify3D User Forum

Hi,

I'm doing a lot of multi-piece printing, and am finding it a hassle to manually assign a separate process per model. (I need to have each model print completely before moving on to the next one)

Is there a way to automatically do this? Automatically have S3D assign one process for each model? I haven't figured it out if so. It takes forever to click through all the menus to do that for a 50 piece print session

Asking the same question in two threads in different forum sections is not going to get you an answer in half the time!

Best to use the thread in the General section....and leave this thread to demote itself in time.

Well I wasn't thinking that way. To me it's a question that fit the general forum in case it can already be done, and then, if not, it was a new feature request.