Simplify3D User Forum

So how do I get the slicer to be smart enough to not try to create a top layer over say a honeycomb infill and just dump plastic in the middle of the honeycomb with no chance in the world it'll ever connect to anything? Is this some kind of bug or am I'm just missing something? I know I can mostly fix this by really increasing the infill percentage and going with say rectilinear, however I would think the slicer would be smart enough to not try to air print inside a honeycomb center. It's very annoying to say the least.



Thanks,

Jeff

This is a known issue: viewtopic.php?f=9&t=3822&hilit=top+layer