Newbie Alert!!
Posted: Fri Feb 03, 2017 10:05 am
Hi,
I've only recently got into 3D printing and just bought S3D which is amazing!
I'm printing on a Qidi Technology Printer and have had great results until later this week.
It prints great but in one area the print appears to "move"
The first layers are perfect circles but after 15 mins when I look again the bottom circle in one area has "warped"
I hope I'm explaining this properly!
I've releveled the table, cleaned the plate.
I'm using glass and 3DLac for adhesion.
Any help would be great thanks,
Jon
I've only recently got into 3D printing and just bought S3D which is amazing!
I'm printing on a Qidi Technology Printer and have had great results until later this week.
It prints great but in one area the print appears to "move"
The first layers are perfect circles but after 15 mins when I look again the bottom circle in one area has "warped"
I hope I'm explaining this properly!
I've releveled the table, cleaned the plate.
I'm using glass and 3DLac for adhesion.
Jon