temperature of the connection layer
Posted: Wed Mar 01, 2017 11:53 pm
setting temp by layer is nice but different temperatures, even when printing with same head are very useful
- general temp
- overhang temp
- small layer temp
- support temp
and whats most important imo
- support interface layer
- object "touching the support"
I'm not sure how these temp options disappeared from slicers over the years, initially all slicers had them (adrian's repraphost, enrique's skeinforge..) at least the basic interface layer's difference .. now I can't find them nowhere
and I would really like to get them back
- general temp
- overhang temp
- small layer temp
- support temp
and whats most important imo
- support interface layer
- object "touching the support"
I'm not sure how these temp options disappeared from slicers over the years, initially all slicers had them (adrian's repraphost, enrique's skeinforge..) at least the basic interface layer's difference .. now I can't find them nowhere
and I would really like to get them back