Simplify3D User Forum

Hello forum users,

my problem is shown here: https://goo.gl/photos/QR8xfSyX8c2LtGGUA. I investigated it with the preview and see that for those travels are no retraction is happen. The option for retraction when cross open spaces is enabled. There are not much of those but for me to much and it really degrades the quality.
I am thankful for all hints to solve that.

Daniel

I have same issue. Try playing with retraction settings. Only retract over open spaces, as well as avoiding those movements in the advanced tab. You can also perform wipes. Start with a distance of 5mm and go from there. You can also turn coast on with distance being .2-.5mm. Flow rate and extruder width can play a part too. Please let me know if you get anywhere