Simplify3D User Forum

Hello everybody,

a feature i would realy wish could be a counter for my materials.

There should be a new menu for Filament properties where you could enter
the roll weight, so that the software can count and tell you when to switch or order
new material.

Sry if this idea had been made, didn't had enough time for searching the forum ^^'

best regards

madda

Hello again,

so, if no one seems to need an filament counter, i'm interested how you are counting your filament ^^

best regards

madda

i'm interested how you are counting your filament ^^

Personally, I don't. But there again, I only print small components.....so gauging if there's enough filament to print one part is more difficult to think about than to do.