Simplify3D User Forum

Like Sli3er have support for Octopi API key so that you can upload your gcode file directly to the Octopi connected to your printer I would like this very much also on Simplify3D - it's very boring to first save a file which you can then upload via the Octopi Web interface.

Also support for the new Prusa Multi-Extruder solution could be fine in next Simplify3D version

Thanks in advance.

/HKOCH

There's already a thread covering this subject. Why not add your thoughts to that thread rather than starting a new one.

viewtopic.php?f=23&t=1924