Simplify3D User Forum

I am bouncing between the dual and single extruder for the Lulzbot Taz 6. It seems like right now people are flashing teh appropriate firmware from the lulzbot CURA edition and then using S3D as their slicer. Im curious if anyone knows a way to flash the firmware from S3D instead of having to take the extra step of using CURA

I'm in the same boat with a Taz 6. I'd like to know also.

My suggestion is to stick with how the manufacturer says to update it. You step outside of their instructions and there is a risk of bricking the board.
Just my 2 cents!