Raft first layer
Posted: Sat Apr 22, 2017 11:41 am
Hey guys,
I have a question.
The printer is a Prusa i3 MK2
When I change the layer height to be for example, 200um to 100um, it increases the height of the first layer of the raft (which sometimes makes it so that the raft doesn't stick to the platform) at a print layer height of 50um it creates the first layer of the raft about 2mm above the platform which then leads to a failed print...
Is there any way to change the first layer height of the raft only?
I have a question.
The printer is a Prusa i3 MK2
When I change the layer height to be for example, 200um to 100um, it increases the height of the first layer of the raft (which sometimes makes it so that the raft doesn't stick to the platform) at a print layer height of 50um it creates the first layer of the raft about 2mm above the platform which then leads to a failed print...
Is there any way to change the first layer height of the raft only?