Simplify3D User Forum

I'm trying to print this attached file, but there are holes in the wings. When scaled down, the holes are larger and auto fix measures don't seem to work here. How do I fix it?

Thanks

I did this recently for an other user on this model. Here is the workflow:
viewtopic.php?f=9&t=7381&p=31861#p31868

MasterFX wrote:I did this recently for an other user on this model. Here is the workflow:
viewtopic.php?f=9&t=7381&p=31861#p31868

Checked it out - I downloaded the fixed file but for some reason it still shows up in S3D with holes in the wings.

Tiger91 wrote:

MasterFX wrote:I did this recently for an other user on this model. Here is the workflow:
viewtopic.php?f=9&t=7381&p=31861#p31868

Checked it out - I downloaded the fixed file but for some reason it still shows up in S3D with holes in the wings.

Ok I tried again a little bit freehand fixing with meshmixer. There are really thin walls, I think that is the problem.

This looks ok to me...:

MasterFX wrote:

Tiger91 wrote:

MasterFX wrote:I did this recently for an other user on this model. Here is the workflow:
viewtopic.php?f=9&t=7381&p=31861#p31868

Checked it out - I downloaded the fixed file but for some reason it still shows up in S3D with holes in the wings.

Ok I tried again a little bit freehand fixing with meshmixer. There are really thin walls, I think that is the problem.

This looks ok to me...:

dragon1.png

That does work - thanks!

Do you know if there's a simple way to thicken thin walls?

Do you know if there's a simple way to thicken thin walls?

Subscribe to the Pro or Plus subscription service at Makeprintable.com and there's a tool to do that!