Page 1 of 1
Support for FlashForge Inventor 3D
Posted: Sat May 13, 2017 11:46 am
by cdknudsen
Will the software support the new Flashforge Inventor? Can i manually configure it until it is included in the printer list? thx
Re: Support for FlashForge Inventor 3D
Posted: Sat May 13, 2017 3:23 pm
by MasterFX
Of cause you can add you printer manually. In this case you could chose a similar model (e.g. Flashforge dreamer) and adjust the printing area etc.
Re: Support for FlashForge Inventor 3D
Posted: Fri Jun 30, 2017 1:57 am
by raz631
Did you end up getting this to work for you?