Rumbling sound printing multiple objects
Posted: Sat May 13, 2017 9:27 pm
I've had no real troubles with Simplify 3D but tonight, I am printing a Raptor Enable prosthetic forearm, many pieces
When the printer finishes and starts the next layer, I can her it rumbling over the top of the pieces and do the next layer
I know in Cura this happens with Combing being enabled Some suggest using z-hop which is noisy but works
What's the best setting in S3D to eliminate this problematic rumbling?
When the printer finishes and starts the next layer, I can her it rumbling over the top of the pieces and do the next layer
I know in Cura this happens with Combing being enabled Some suggest using z-hop which is noisy but works
What's the best setting in S3D to eliminate this problematic rumbling?