Bed Marking Method.
Posted: Mon May 22, 2017 2:38 pm
A feature within Simplify3D that allows you to mark an area on the bed that is damaged so you can avoid a model being placed on top of it.
It would be useful if the virtual bed grid had identifiers in centimeters at each edge, similar to how a chessboard is marked with numbers and letters. Then if someone had a chip in their bed, they could locate the coordinates by measuring it on their bed and mark that area as a 'no-go' zone in Simplify3D's.
Maybe the software could allow them to draw a shape on the bed and that shape is highlighted in red to represent a damaged area where you don't want models to be printed.
It would greatly help people with a damaged area on their bed who don't want to have to replace it.
It would be useful if the virtual bed grid had identifiers in centimeters at each edge, similar to how a chessboard is marked with numbers and letters. Then if someone had a chip in their bed, they could locate the coordinates by measuring it on their bed and mark that area as a 'no-go' zone in Simplify3D's.
Maybe the software could allow them to draw a shape on the bed and that shape is highlighted in red to represent a damaged area where you don't want models to be printed.
It would greatly help people with a damaged area on their bed who don't want to have to replace it.