Last layer
Posted: Wed May 31, 2017 10:29 pm
Hi, i'm using a 1mm nozzle.
For improve the quality of the first layer im using firstlayer width: 50% (with this the first layer Is filled completely) i want to do the same for the last layer of the print.
My question is if exist a G command or something to change the last layer width?
Thanks!
For improve the quality of the first layer im using firstlayer width: 50% (with this the first layer Is filled completely) i want to do the same for the last layer of the print.
My question is if exist a G command or something to change the last layer width?
Thanks!