Exclude Parts of the Bed.
Posted: Thu Jun 22, 2017 5:24 am
Hello,
i usually print PETG on Glas, sometimes small pieces auf glas are breaking out of the glas.
That doesn't mean the bed isn't usable anymore, i rearrange the parts around this faulty part.
But sometimes i forget, or do it not accurate enough.
I would be helpful to be able to "blacklist" parts of the bed so that auto arrange does not use them.
Thanks
i usually print PETG on Glas, sometimes small pieces auf glas are breaking out of the glas.
That doesn't mean the bed isn't usable anymore, i rearrange the parts around this faulty part.
But sometimes i forget, or do it not accurate enough.
I would be helpful to be able to "blacklist" parts of the bed so that auto arrange does not use them.
Thanks