different speeds for retraction and extrusion

[JeffJordan]

simply as described in the subject: different speeds for retraction and extrusion would be nice.
there are freeware slicers availabel (KISS), that can deal with different speeds... the slicer (s3d) I payed for can't .

why is this important ? because optimizing retraction and extrusion are essential for perfect quality prints... without stringing and unwanted artefacts due to interruptions of filament flow. some musings about this topic could be found here.

[NitroXpress]

Hi,

I'm not quite sure what you mean exactly...
But what about the "Rectraction Speed" in the Ooze Control settings ?

Frank