Simplify3D User Forum

Hello,

I bought this software as it said it supports solidoodle 3. There is no profile for it so I use the other solidoodle profiles but I can't figure out where to set the print area size.

It's not obvious anyway.

Does anyone have a S3 profile?

Not much has changed between the Solidoodle 2 and 3. In fact, there hasn't been much different from 1, 2, 3, or 4! Pretty much the same core components all the way through.

Probably all you need to do is change the build volume. I would start with the Solidoodle 2 Pro profile. Then click on the G-Code tab of your FFF Settings, and update the Build Dimension Overrides with the appropriate build dimensions.