Page 1 of 1
Open Previous Models Upon Restart
Posted: Tue Jul 25, 2017 11:27 am
by LHawes
4.0 Does not open previous models upon restart as 3.1 did. Is that intended? For example I load 2 models for slicing, close the software and reopen. The previous 2 models are not open as was in 3.1.
Re: Open Previous Models Upon Restart
Posted: Tue Jul 25, 2017 11:32 am
by brian442
It works fine for me. It still reloads all of my old models just like it did before. You might want to go to Tools > Options (or Simplify3D > Preferences if you're using macOS) and make sure that "Save and restore application state" is enabled.
Re: Open Previous Models Upon Restart
Posted: Tue Jul 25, 2017 12:21 pm
by AndersE
Works on both my machines.
Re: Open Previous Models Upon Restart
Posted: Tue Jul 25, 2017 12:30 pm
by bbinnard
Works OK for me too - Win10-64.