Simplify3D User Forum

Can you please put a note or link on the release notes page to how you activate the new features?

https://www.simplify3d.com/software/rel ... ion-4-0-0/

As an example, I'm a reasonably new user and I found it very difficult to figure out how to enable the new dynamic gap fill feature. And to be honest, I'm still not 100% sure I have. It also took me way more time than I should admit to find the new view on the print preview.

Thanks,
Chad

There's a really good post towards the end of this thread that explains a lot of the dynamic gap fill stuff:
viewtopic.php?f=23&t=3471&start=110#p33950