Simplify3D User Forum

Hi,

is there anyway to choose the support infill angle when you do manual support?

Thanks

Try setting it under supports and see how that works. I think I did that.

Just to clarify whirlybird's reply.......the angles of supports, either manual or automatically created, are defined in the Support Infill Angles box in the Support tab in the profile settings. You can define one or more angles by adding to the list in the table using the Add angle button and value field.

There are not different angle settings for manual and automatic supports.

dkightley wrote:Just to clarify whirlybird's reply.......the angles of supports, either manual or automatically created, are defined in the Support Infill Angles box in the Support tab in the profile settings. You can define one or more angles by adding to the list in the table using the Add angle button and value field.

There are not different angle settings for manual and automatic supports.

Appreciate the assist!!

Thanks, you are right it still reads it form there.

Old post but turned up on a search for Support Infill angles .. but I took a look at the tip of the day and found my answer so here is the link for the next person doing a search.
viewtopic.php?f=8&t=2135