How to setup filament profiles in v4

[moth4017]

I find i hard to believe that Simplify 3D has printer profiles but no Filament profiles. most people would only have 1 printer but use many different filament at different temperatures and speeds , but there seems no way of setting up profiles for Filament..

Have i mist something or is this an issue for many of you?

[brian442]

This video shows how to do it:
https://www.youtube.com/watch?v=JFynhtvPBPQ

[AK_Eric]

Not a thing that S3D does, unfortunately. Similar question was asked here:
viewtopic.php?f=8&t=7957

I have a spreadsheet of data for each filament I have to re-enter every time I swap filaments.