arhi wrote: ↑Wed Aug 23, 2017 8:43 am
you can already do this with s3d, I did it few times, create another process on top of the final layer that's 0.1 or 0.05mm off the top, set for that process 0.1 or 0.05mm layer and reduce extrusion multiplier a lot (you can even increase the temp) and that's it .. that process will do the ironing
That is only limited to the top surface of one final layer only, many models have multiple horizontal surfaces at various heights throughout the model, this would not work for that. For instance, think of a flight of stairs. You want the ironing on every stair, not just the top one. You could create a process for each stair, but that would be tedious. Plus there are much more complex models than a simple staircase which would be difficult if not impossible to do ironing for every top surface.