Page 1 of 1
Collision avoidance - toolhead model
Posted: Wed Aug 30, 2017 10:37 am
by sstantz
It would be great to be able to input a basic model of toolhead geometry to allow S3D to automatically check for collisions that might occur during a print, especially for sequential printing. Parts that are close together sometimes take a small bump from my nozzle.
Re: Collision avoidance - toolhead model
Posted: Sat Sep 02, 2017 5:33 pm
by BladerunnerxRC
This would be interesting.
Re: Collision avoidance - toolhead model
Posted: Wed Feb 06, 2019 2:54 pm
by Menissalt
Old request but one I would like to see as well
Re: Collision avoidance - toolhead model
Posted: Thu Feb 07, 2019 5:02 am
by Miklb
An improvment allready suggest in this post :
viewtopic.php?f=23&t=12692