Page 1 of 1
Gaps between perimeters and infill visible in g code
Posted: Sat Sep 30, 2017 2:11 pm
by JD95
In a part I was making today, I found areas where material wasn't being placed, leaving unwanted one-bead gaps between surface infill and perimeters, where interior infill wasn't being placed like it should have been, or better yet, the "top" layer extended to the perimeter.
Re: Gaps between perimeters and infill visible in g code
Posted: Sat Sep 30, 2017 2:13 pm
by JD95
Separate STL in case it's needed. See above post for the factory file.
Re: Gaps between perimeters and infill visible in g code
Posted: Sat Sep 30, 2017 4:05 pm
by dkightley
Set your perimeter/shells to 4.....or change infill to 100%
Your "gap" is the 50% infill that is not being filled because there's only one filament with available.
Re: Gaps between perimeters and infill visible in g code
Posted: Sat Sep 30, 2017 4:22 pm
by JD95
It does the exact same thing at 0% (oops duh on me), 10%, 30% and 100% infill, and probably everything in between.
I can add perimeters but I think it's a workaround. It's a situation that I would appreciate it if the slicer can avoid doing in the first place. It seems to be a bug that pops up only when the remaining gap for interior infill is one bead width wide or narrower.