Simplify3D User Forum

Any chance for a profile for the new Neva from Dagoma??

up ...
I intend to buy S3d for my Dagoma Neva but without this profile, I won't.

I have a Neva profile just about ready to go. Been using S3D exclusively with my Neva for the past 2 weeks. A couple more tests to perform to finish dialing in the first layer settings and I'll be publishing it back to Simplify3D.

I would also be very interested in this. Thank you for taking the time to figure it out.

I am in the same situation, and I confess to be a little disappointed .... I bought the software, because the Dagoma Neva was supposedly compatible, yet at the opening of the software there is no profile for the Dagoma Neva.

Is there a solution?

Please contact our support team. They'd be happy to provide you with a profile for use with your Dagoma Neva.

I actually used someones profile from facebook then tweaked it to make it work for me.