Compatibility with Flashforge Inventor II (aka Finder 2)?
Posted: Sun Oct 08, 2017 12:25 am
Apologies if this is an easily solvable question but I haven't been able to find an answer anywhere.
Does anyone know if Simplify3D will work with the Inventor II? Considering it is almost identical to the Flashforge Finder but with a 10mm bigger printing bed I was hoping it would just work with Finder selected as the printer or perhaps a setting or two changed?
Any help would be greatly appreciated, thanks.
Does anyone know if Simplify3D will work with the Inventor II? Considering it is almost identical to the Flashforge Finder but with a 10mm bigger printing bed I was hoping it would just work with Finder selected as the printer or perhaps a setting or two changed?
Any help would be greatly appreciated, thanks.