shasselberg
Posts: 21
Joined: Thu Mar 31, 2016 9:16 pm

Network Printing

Will it every be possible to print directly over the network to network-enabled printers, either WiFi or ethernet?
ddhawk
Posts: 2
Joined: Sun Aug 26, 2018 6:35 pm

Re: Network Printing

Add me to this request. Dremel 3D45 could use support for printing over WiFi.
argh
Posts: 3
Joined: Mon May 06, 2019 10:49 pm

Re: Network Printing

Make that 3 for Dremel 3D45.

I am so incredibly disappointed that the printer is "supported" but I can't use the wifi.
S3D-Jake
Posts: 994
Joined: Wed Jun 20, 2018 12:45 pm

Re: Network Printing

Thanks for your feedback and suggestions. I believe the original intention of this thread from 2017 was to add network printing support in a more general sense. However I'll document your specific requests for 3D45 network printing support for our development team. In addition, I'll continue to monitor this thread for other network printing requests.
"A bird does not sing because it has an answer. It sings because it has a song."
markauskas
Posts: 3
Joined: Sun May 12, 2019 4:57 am

Re: Network Printing

Support for Duet3D boards would be great as well.
S3D-Jake
Posts: 994
Joined: Wed Jun 20, 2018 12:45 pm

Re: Network Printing

Thanks for including the Duet3D Wifi / Ethernet as a mentioned printer board that supports network printing. Which revision of the board do you have? I'll add this to the feature request's documentation.
"A bird does not sing because it has an answer. It sings because it has a song."
Ret
Posts: 80
Joined: Wed Feb 07, 2018 4:26 pm

Re: Network Printing

I second the support for network printing with Duet boards.
hectorri
Posts: 2
Joined: Mon Sep 10, 2018 4:07 pm

Re: Network Printing

+1 to Duet3d Support.
markauskas
Posts: 3
Joined: Sun May 12, 2019 4:57 am

Re: Network Printing

S3D-Jake wrote: Mon May 13, 2019 2:01 pm Thanks for including the Duet3D Wifi / Ethernet as a mentioned printer board that supports network printing. Which revision of the board do you have? I'll add this to the feature request's documentation.
I have a Duet 2 Wifi v1.03
BobMinteer
Posts: 1
Joined: Fri Oct 21, 2016 12:10 pm

Re: Network Printing

I am in the midst of converting my DaVinci Pro 1.0 to Duet3D v1.04.

I am always happier with my prints when when using S3D rather than the XYZ slicer.

So... I am all for supporting WiFi printing for RepRapFirmware / Duet.

Return to “Feature Requests”