Simplify3D User Forum

Hello, I am a Newbie,

I read through the forum, but did not see anything that is similar to my problem.
I tried to print a cylindric body with PLA and Easywood.
When I turn on the retraction (3mm retraction Speed900) than there i a big blob on all layers.

When I turn off the retraction, than I have this "gap" on every layer.

On which Parameters of retraction should I concentrate to avoid the failure?

Which informations do you need also, to help me?

Thanks

That means you still need to adjust your retraction settings, since that's what's causing the blob.

If you're new, there's a good section about this here:
https://www.simplify3d.com/support/prin ... s-and-zits

Thanks,

yes I am stll very green in the "filed" I will try to check these thinks