Simplify3D User Forum

Hi,


I am a new user, so first off please let me say I have been loving simplify3d, overall it was a really good investment, so thanks!
I am experiencing one big quirk though:

No matter how I arrange my stl files in simplify 3D, they always end up printing to the far side of the heated bed of my rasied 3D n2 Plus. Usually towards the middle of the far side.

While this sounds harmless, it provides really big issues when printing multiple objects. See pics in links below:


https://www.dropbox.com/s/q17l6w1yxa4r5 ... o.jpg?dl=0
https://www.dropbox.com/s/lo6s9d95yxgss ... o.jpg?dl=0


Am I missing a setting or something, what might cause this?

Are you using the stock Raise3D profile from the configuration assistant in S3D? Might want to try going back to Help > Configuration Assistant, and re-downloading that profile. Then don't make any changes and see if this still happens.

Brian,


Thank you for your response. I will try this next.
Is there a setting / settings related to this that may have caused this?