Would it be possible to add how much estimated time is remaining under the percentage complete? it doesn't need to be perfect, just a countdown from the original time would be good enough or calculate it from the original estimated time combined with the percentage complete. i haven't checked how accurate the estimated time is so it may be way off but even on some smaller prints makerbots can be off by like 5-10 minutes (as in it will say 0 minutes left and continue printing for 5-10 minutes) so if its only off by a few minutes i don't think it would be an issue. it would just be nice to get a general idea of how much longer a print might be and if i should stay up at night a little longer to start a new one.
EDIT: ok, so for one print today it did have a time remaining by the percentage complete, but then on my next print it was gone again... Do i just have a bug or some setting not setup properly?
-
Snakester15
- Posts: 3
- Joined: Fri Jan 05, 2018 7:24 pm
Time Remaining
Last edited by Snakester15 on Sun Jan 07, 2018 7:25 pm, edited 1 time in total.
-
Snakester15
- Posts: 3
- Joined: Fri Jan 05, 2018 7:24 pm
Re: Time Remaining
Ok, WTF, now there is a time remaining buy percentage complete. i know it wan't there last night, so did they add it overnight or was i just having a bug with it not displaying?
Re: Time Remaining
You aren't crazy. I saw it the other night as being there, but now it is gone again.
